Product Description
Half Inch Coaxial Cable Easiax Prep Tool. It is manufactured by Andrew antenna & wire company that is now owned by CommScope communication infrastructure company. This EASIAX manual cable preparation tool is made for use with half inch HELIAX coaxial cables including LDF4-50, HL4RP-50, and RXL4 series inch foam dielectric cables.
This cable hand prep tool MCPT-L4 helps prepare cable quickly and consistently. This cable cutting tool cuts precisely at the crest of the copper corrugation and at the exact distance required for easy connector attachment. The cable stripper tool produces a clean cut which makes flaring the coaxial cable easier.
The precise blade depth makes it impossible to cut the inner conductor. For fast, clean, and consistent HELIAX cable preparations go with this Andrew Solutions EASIAX manual cable preparation tool. For cables with thickness of half an inch only.
Note: For any signal booster to help, outside signal strength must be at least -110 dB or there must be a clear line of sight to a cell tower that is within twenty miles. Before ordering, please check outside signal level in decibels or ensure that you can make and hold a phone call at any good spot outside where you can mount an exterior antenna. Square footage stated in signal booster listings is based on good signal outside. If it is any weaker, the boosted sq. ft. area will be considerably lower, accordingly.
Kevin K. of Anderson, California gave the following review:
Website is easy to use with plain straight forward info but could have had more on testing signal strength to make sure you get a strong enough booster.
Therefore, please note that stated sq. ft. coverage is based on good signal outside. For best results: If outside signal is weak, we suggest choosing the next higher sq. ft. coverage kit. If outside signal is very weak, we suggest choosing the kit with even more higher sq. ft. range bracket. Basically, higher the sq. ft. bracket, the more powerful the signal amplifier with greater Gain as well as higher uplink and downlink output power.
If outside signal is too weak (weaker than -110 dB), submit request for cell coverage solution assessment. Upon receipt of questionnaire, we will perform residential or business site survey. This will help us determine the system that is needed to improve cell coverage. Then, we will create system design using that system such as femtocell, active or hybrid distributed antenna system (DAS), or other carrier feed signal enhancing method available that will work at your signal-challenged location. Finally, we will schedule for installation after equipment and installation service quote has been approved by you, or your company.
For non installation-included kits: Most home / office / building cell signal booster kits only include bracket to mount exterior antenna on outside wall, edge of roof, or existing pipe up to 2 inches in diameter. Mounting pole not included with most kits, unless stated specifically that it is included for free. Therefore, a mounting post must be purchased separately if you will require it to mount exterior antenna.
![]()
